Engenius ESR300H Router Firmware

Specifications:

Hardware Specifications
Physical Interface
- Antenna Connector
- Power Jack
- LAN: 10/100 Ethernet RJ45
- WAN: 10/100 Ethernet RJ45
- Power Switch
LED’s Status
- WPS (Press 1-to 5 seconds to activate the router’s Wi-Fi Protected Setup (WPS) feature.
- (Press 6-to-10 seconds to reboot the router)
- (Press up to 20 seconds to reset the router to factory default)
- Power Status

WAN Internet Connection
LAN LAN1 – LAN4
WLAN Wireless Connection

RF Specifications
- Frequency Band 2.400 – 2.484 GHz
- Modulation Technology
- OFDM: BPSK, QPSK, 16-QAM, 64-QAM
- BPSK, DQPSK, CCK
- Operation Channels 11 for North America, 13 for Europe, 14 for Japan
- Receive Sensitivity
- (Optimal) -90 dBm
- Available Transmit Power (Optimal) 23dBm
- Antenna 2 detachable 2 dBi

Software Features
- Router and Gateway
- Operation Mode AP / Router / WDS

LAN
- DHCP Server
- Static Routing Table
- UPNP

WAN Static IP, Dynamic IP, PPPo, PPTP, L2TP

Router
- NAT / NAPT
- Static Routing-RIPv2
- Dynamic Routing
- Virtual Server Mapping
- IP address Mapping
- Port Forwarding
- Port Triggering
- MAC Address Filtering
- ALG (Application Layer Gateway) Support

Firewall
- Block ICMP
- SPI (Static Packet Inspection)
- DoS Attack Blocking
- Rule Based (IP Address Ranges, Port Ranges &
- Schedule)
- DMZ (Demilitarized Zone) Host Support

Parental Control
- Time Based Internet Access Control
- URL / Keyword Filtering

VPN
- L2TP & PPTP VPN tunneling
- VPN pass-through (PPTP, L2TP, IPSEC)

Wireless
- WEP
- WPA
- WPA2
- 802.1x Authenticator
- Hide SSID in beacons
- WPS
- Auto Channel Selection
QoS WMM

Please do not forget to check with our site as often as possible in order to stay updated on the latest drivers, software and games.

Note: Try to set a system restore point before installing a device driver. It will help you restore system if installed driver not complete.