Gigabyte GA-M56S-S3 (rev. 1.x) NVIDIA MCP65 SATA RAID Preinstall Driver 12.15

CPU    
1. Support for Socket AM2+/ AM2 processors: AMD PhenomFX processor/ AMD Phenom processor/ AMD Athlon 64 FX processor/AMD Athlon 64 X2 Dual-Core processor/AMD Athlon 64 processor/AMD Sempron processor

(Note) If you install AMD AM2+ CPU on AM2 motherbord, the system bus speed will downgrade from HT3.0(5200MHz) to HT1.0(2000 MT/s) spec; however, the frequency of AM2+ CPU will not be impacted. Please refer \"CPU Support List\" for more information.

Chipset    
1. NVIDIA nForce 560
2. Super I/O: ITE IT8716 chip
3. Integrated Peripherals:
1. T.I IEEE1394 controller
2. Realtek 8211BL Gigabit Ethernet Phy
3. Realtek ALC888 Audio Codec 

Memory    
1. 4 DDR2 DIMM memory slots (supports up to 16GB memory)
2. Supports dual channel DDR2 800/667/533/400 DIMMs
3. Supports 1.8V DDR2 DIMMs 

Internal I/O Connectors    
1. 1 24-pin ATX power connector
2. 1 4-pin ATX 12V power connector
3. 1 floppy connector
4. 1 IDE connector
5. 4 SATA 3Gb/s connectors
6. 1 CPU fan connector
7. 1 system fan connector
8. 1 front panel connector
9. 1 front audio connector
10. 1 CD In connector
11. 1 SPDIF In connector
12. 1 SPDIF out connector
13. 3 USB 2.0/1.1 connectors for additional 6 USB 2.0/1.1 ports by cables
14. 2 IEEE1394a connectors for additional 2 port by cables
15. 1 chassis intrusion header
16. 1 Power LED connector 

Expansion Slots    
1. 1 PCI Express x 16 slot
2. 2 PCI Express x 1 slots
3. 4 PCI slots 

Back Panel Connectors
1. 1 PS/2 keyboard port
2. 1 PS/2 mouse port
3. 1 parallel port
4. 1 SPDIF out port (coaxial)
5. 1 SPDIF out port (optical)
6. 1 serial port (COMA)
7. 4 USB 2.0/1.1 ports
8. 1 IEEE1394 port
9. 1 RJ-45 port
10. 6 audio jacks (Line In / Line Out / MIC In / Surround Speaker Out (Rear Speaker Out) / Center/Subwoofer Speaker Out / Side Speaker Out) 

Power    
1. ATX power connector and ATX 12V connector 

Form Factor
1. ATX form factor; 30.5cm x 21.4cm 

H/W Monitoring    
1. System voltage detection
2. CPU/System temperature detection
3. CPU/System fan speed detection
4. CPU/System overheating warning
5. CPU/System fan fail warning
6. CPU/System fan speed control

BIOS    
1. 1 4Mbit flash ROM
2. Use of licensed AWARD BIOS 

Other Features    
1. Supports @BIOS
2. Supports Download Center
3. Supports Q-Flash
4. Supports EasyTune 
5. Supports Xpress Install
6. Supports Xpress Recovery2
7. Supports Virtual Dual BIOS 


It is highly recommended to always use the most recent driver version available.

Do not forget to check with our site as often as possible in order to stay updated on the latest drivers, software and games.

Try to set a system restore point before installing a device driver. This will help if you installed a wrong driver. Problems can arise when your hardware device is too old or not supported any longer.