Gigabyte GA-P55A-UD3 (rev. 1.0) SATA2 Preinstall Driver 1.17.54.1

CPU
1. Support for an Intel Core i7 series processor/Intel Core i5 series processor in the LGA1156 package
2. L3 cache varies with CPU 

Chipset    
1. Intel P55 Express Chipset 

Memory    
1. 4 x 1.5V DDR3 DIMM sockets supporting up to 16 GB of system memory
2. Dual channel memory architecture
3. Support for DDR3 2200/1600/1333/1066/800 MHz memory modules
4. Support for non-ECC memory modules
5. Support for Extreme Memory Profile (XMP) memory modules 

Audio    
1. Realtek ALC888 codec
2. High Definition Audio
3. 2/4/5.1/7.1-channel
4. Support for S/PDIF In/Out
5. Support for CD In 

LAN    
1. 1 x RTL8111D chip (10/100/1000 Mbit) 

Expansion Slots    
1. *1 x PCI Express x16 slot, running at x16 (PCIEX16) (The PCIEX16 slot conforms to PCI Express 2.0 standard.)
2. *1 x PCI Express x16 slot, running at x4 (PCIEX4)
3. 2 x PCI Express x1 slots
4. 3 x PCI slots 

Multi-Graphics Technology    
1. Support for ATI CrossFireX technology 

Storage Interface
Chipset:
1. 6 x SATA 3Gb/s connectors (SATA2_0, SATA2_1, SATA2_2, SATA2_3, SATA2_4, SATA2_5) supporting up to 6 SATA 3Gb/s devices
2. Support for SATA RAID 0, RAID 1, RAID 5, and RAID 10 

Marvell 9128 chip:
1. 2 x SATA 6Gb/s connectors (GSATA3_6, GSATA3_7) supporting up to 2 SATA 6Gb/s devices
2. Support for SATA RAID 0 and RAID 1 

iTE IT8213 chip:
1. 1 x IDE connector supporting ATA-133/100/66/33 and up to 2 IDE devices 

iTE IT8720 chip:
1. 1 x floppy disk drive connector supporting up to 1 floppy disk drive 

USB Chipset:
1. Up to 12 USB 2.0/1.1 ports (8 on the back panel, 4 via the USB brackets connected to the internal USB headers) 

NEC chip:
1. Up to 2 USB 3.0/2.0 ports on the back panel 
* USB 3.0 10x performance is a maximum theoretical value. Actual performance may vary by system configuration.

Internal I/O Connectors    
1. 1 x 24-pin ATX main power connector
2. 1 x 8-pin ATX 12V power connector
3. 1 x floppy disk drive connector
4. 1 x IDE connector
5. 6 x SATA 3Gb/s connectors
6. 2 x SATA 6Gb/s connectors
7. 1 x CPU fan header
8. 2 x system fan headers
9. 1 x power fan header
10. 1 x front panel header
11. 1 x front panel audio header
12. 1 x CD In connector
13. 1 x S/PDIF In header
14. 1 x S/PDIF Out header
15. 2 x USB 2.0/1.1 headers
16. 1 x serial port header
17. 1 x parallel port header
18. 1 x clearing CMOS jumper 

Back Panel Connectors    
1. 1 x PS/2 keyboard or PS/2 mouse port
2. 1 x coaxial S/PDIF Out connector
3. 1 x optical S/PDIF Out connector
4. 8 x USB 2.0/1.1 ports
5. 2 x USB 3.0 ports
6. 1 x RJ-45 port
7. 6 x audio jacks (Center/Subwoofer Speaker Out/Rear Speaker Out/ Side Speaker Out/Line In/Line Out/Microphone) 

I/O Controller    
1. iTE IT8720 chip

H/W Monitoring    
1. System voltage detection
2. CPU/System temperature detection
3. CPU/System/Power fan speed detection
4. CPU overheating warning
5. CPU/System/Power fan fail warning
6. CPU/System fan speed control 

BIOS    
1. 2 x 16 Mbit flash
2. Use of licensed AWARD BIOS
3. Support for DualBIOS
4. PnP 1.0a, DMI 2.0, SM BIOS 2.4, ACPI 1.0b 

Unique Features    
1. Support for @BIOS
2. Support for Q-Flash
3. Support for Xpress BIOS Rescue
4. Support for Download Center
5. Support for Xpress Install
6. Support for Xpress Recovery2
7. Support for EasyTune
8. Support for Dynamic Energy Saver 2
9. Support for Smart 6
10. Support for Auto Green
11. Support for eXtreme Hard Drive
12. Support for Q-Share 

Bundle Software    
1. Norton Internet Security (OEM version) 

Form Factor    
1. ATX Form Factor; 30.5cm x 24.4cm



It is highly recommended to always use the most recent driver version available.

Do not forget to check with our site as often as possible in order to stay updated on the latest drivers, software and games.

Try to set a system restore point before installing a device driver. This will help if you installed a wrong driver. Problems can arise when your hardware device is too old or not supported any longer.