OCZ Toolbox Firmware Updater 3.02.14 / Vertex 4 SSD Firmware

WARNING: This is NOT a Destructive Flash for firmware version 1.4 and newer. This is a Destructive Flash for firmware version 1.3 & 1.4RC, back up all data on SSD. Proceeding with this update will result in complete loss of data on the SSD. You will not be able to revert back to a previous firmware revision.

For firmware version 1.3 & 1.4RC, this firmware tool cannot update on a primary boot drive.

WARNING: This is a two step firmware update process for firmware older than 1.4.1.2. Otherwise it is a one step process.

1. Run OCZ Toolbox. Toolbox will update firmware to 1.4.1.2 first.
2. Shutdown and restart the system.
3. Run OCZ Toolbox again, Toolbox will now update to the latest firmware revision.

This completes the firmware update.

OCZ Toolbox version 3.02.14
---------------------------
- Added feature to allow firmware update on Everest2 controllers primary drive
- Modified warning messages for 2 step firmware update process on Vertex4 and Agility4 drives

Known Issues:
- Firmware update feature prohibited on primary drives with 1500, 2000, and Everest1 controllers
- BIOS update feature is prohibited on primary drives

Improvements since version 1.4.1.3:

Enhancements:
• Improved sequential file transfer performance for 128GB, 256GB and 512GB models
• Optimized idle garbage collection algorithms to extend the benefits of performance mode by enabling the feature across a greater percentage of the drive
• Improved HBA / RAID card compatibility
• Further improved compatibility with desktop and mobile ATA security features

Fixes:
• Corrected a corner case issue where the ‘Remaining Life’ SMART attribute could be reported incorrectly

Please do not forget to check with our site as often as possible in order to stay updated on the latest drivers, software and games.

Note: Try to set a system restore point before installing a device driver. It will help you restore system if installed driver not complete.