EnGenius ESR9752 Router Wireless Firmware

Specification

RF Specification
- Frequency Band 2.400–2.484 GHz
- Modulation Technology OFDM: BPSK, QPSK, 16-QAM, 64-QAM
- DBPSK, DQPSK, CCK
- Operation Channels 11 for North America, 14 for Japan, 13 for Europe
- Wireless Mode 11b/11g/11n
- Channel Selection (Setting varies by Country)
- Channel Bandwidth (Auto, 20Mhz, 40Mhz)
- Transmission Rate 11g: Best. 54, 48, 36, 24, 18, 12, 11, 9, 6, 5.5, 2, 1 in Mbps

Receive Sensitivity (Typical)
- IEEE 802.11n (2RX)
- MCS0/8@ -91dBm • MCS7/15@ -74dBm
- IEEE 802.11g (2RX)
- 6Mbps@ -92dBm • 54Mbps@ -75dBm
- IEEE 802.11b (1RX)
- 1Mbps@ -93dBm • 11Mbps@ -91dBm
Available Transmit Power
- IEEE 802.11n: MCS 0 –15@ >16dBm
- IEEE 802.11g: 6 – 54 Mbps@16dBm
- IEEE 802.11b: 1, 11Mbps@19dBm

Antenna 2
Peak Gain=2 dbi with SMA connector (detachable)

Software Features

Topology Infrastructure
Operation Mode AP/Router
LAN
- DHCP Server
- Static Routing Table
- UPNP

WAN
PPTP • PPPoE • Static IP • DHCP Client • Clone MAC address

Router
- NAT/ NAPT
- Static Routing
- Dynamic Route
- Virtual server mapping
- IP address mapping
- Port Forwarding
- Port Triggering
- Special application
- ALG(Application Layer Gateway) support (RTP/RTSP, AOL, FTP, ICMP, WMP/MMS, NetMeeting, SIP)
- DNS Relay
- DDNS
- Time Zone(NTP client)

Firewall
- Block ICMP Ping
- DoS(Block ICMP Ping, Port scan, Sync Flood)
- MAC/IP Filtering
- ICMP Blocking
- SPI (Stateful Packet Inspection)
- DMZ (Demilitarized Zone) Host
- Policy Based Parental Controls
- Port Range / Service Filtering
- Internet Domain Restriction
VPN
- VPN pass-through (PPTP, L2TP, IPSEC)

Wireless
- Power saving(Green technology)
- 64/128 bit WEP Encryption
- WPA Personal (WPA-PSK using TKIP or AES)
- WPA Enterprise (WPA-EAP using TKIP)
- 802.1x Authenticator
- Hide SSID in beacons
- Wi-Fi Protection Setup (WPS)
- WDS
- ACL control
- Best Channel selection
- Speed/Bandwidth monitor
QoS
- WMM
- Application base
- Priority Queue
- Bandwidth Allocation

Management

Configuration Web-based configuration (HTTP)
Firmware Upgrade Via webpage upgrade
Auto recovery if firmware upgrade fails
Administrator Setting Administrator password change • Idle time out
Reset Setting Reboot • Reset to Factory Default
System monitoring Speed and bandwidth monitoring
Scheduling Enable Firewall • Enable power saving
Easy Access User can type model name and access the main page
Install wizard Guides user to set-up router smoothly

Environment & Physical

Temperature Range
- Operating: 0°C to 45°C (32°F to 113°F)
- Storage: -10°C to 70°C (14°F to 158°F)
Humidity (non-condensing) 15% – 95% typical

Please do not forget to check with our site as often as possible in order to stay updated on the latest drivers, software and games.

Note: Try to set a system restore point before installing a device driver. It will help you restore system if installed driver not complete.